07.14.15
FlexTech Alliance announced the successful conclusion to its Large-Area Roll-to-Roll In-Line Surface Metrology Program with 4D Technology Corporation of Tucson, AZ. The product, the FlexCam Defect and Roughness Metrology Module, was launched to substantial interest in February at 2015FLEX in Monterey and will be featured in several upcoming events. This project was started in 2012 with the intent of developing high-speed inspection and measurement — two important measures of success in roll-to-roll manufacturing of electronics.
The project started with a request from FlexTech members for an inspection system that could provide insight into the characteristics of a web in motion. 4D Technology proposed, and was accepted to complete, the project. The company’s final product has exceeded several of the original technical targets and has demonstrated the expectation for further improvement. Originally intended for barrier film manufacturers, the FlexCam is also gaining interest for characterizing substrates and intermediate layers.
Interest has also been seen in other market areas, including non-roll-to-roll applications, precision optics manufacturing, and in place measurement of roughness on polished metal parts in precision machining centers.
“The quick entrance to the industry and commercial interest in this unit is indicative of a successful FlexTech project,” said Malcolm Thompson, CTO at FlexTech Alliance. “4D Technology is delivering an advanced and easily-customizable tool to an industry that is re-writing the way electronics are built. It is supply chain advancements like this one that will enable a fully-realized Internet-of-Everything.”
The project started with a request from FlexTech members for an inspection system that could provide insight into the characteristics of a web in motion. 4D Technology proposed, and was accepted to complete, the project. The company’s final product has exceeded several of the original technical targets and has demonstrated the expectation for further improvement. Originally intended for barrier film manufacturers, the FlexCam is also gaining interest for characterizing substrates and intermediate layers.
Interest has also been seen in other market areas, including non-roll-to-roll applications, precision optics manufacturing, and in place measurement of roughness on polished metal parts in precision machining centers.
“The quick entrance to the industry and commercial interest in this unit is indicative of a successful FlexTech project,” said Malcolm Thompson, CTO at FlexTech Alliance. “4D Technology is delivering an advanced and easily-customizable tool to an industry that is re-writing the way electronics are built. It is supply chain advancements like this one that will enable a fully-realized Internet-of-Everything.”